Menu
APCOMIN INDUSTRIAL SYNTHETIC ENAMEL
FEATURES & RECOMMENDED USE
- General purpose enamel suitable for industrial atmospheric conditions
- Can be applied over intact alkyd, epoxy and polyurethane coatings
- Easy application by brush with good flow
- Meets performance requirements of IS 2932 specification
- Good colour retention
PRODUCT DATASHEET
TECHNICAL DATA
| Property | Value |
|---|---|
| Colour Range | — |
| Gloss | Glossy |
| Volume Solids | Approx. 30% |
| Recommended DFT / Coat | 20 – 25 microns |
| Theoretical Covering Capacity | 15.00 sq.m/l @ 20 µm DFT 12.00 sq.m/l @ 25 µm DFT |
| Drying Time at 30°C | Surface Dry: 4 hours Hard Dry: 12 hours |
| Overcoating Interval at 30°C | Min: 12 hours Max: Unlimited (surface cleaned from all contamination) |
| Shelf Life (Cool & Dry Place) | At least 12 months |
| Flash Point | Not less than 30°C |
DIRECTIONS FOR USE
Surface Preparation & Substrate Condition
- Suitable alkyd / epoxy primer or intermediate coat, dry and free from any contamination
- For aged alkyd or epoxy coatings, surface must be sufficiently roughened if necessary
- Substrate temperature must be at least 3°C above dew point, not above 50°C
MIXING
- If settling is observed, loosen material with a hand stirrer,
then mix thoroughly using a power-driven stirrer for homogeneous mixing
APPLICATION
Application Method & Parameters
Airless Spray
| Parameter | Value |
|---|---|
| Recommended Thinner | T-284 |
| Volume of Thinner | 0 – 5% |
| Nozzle Orifice | 0.28 mm |
| Nozzle Pressure | 12 MPa (≈ 120 atm / 1700 psi) |
Air Spray
| Parameter | Value |
|---|---|
| Recommended Thinner | T-284 |
| Volume of Thinner | 10 – 15% |
| Nozzle Orifice | 1.8 – 2.0 mm |
| Nozzle Pressure | 0.3 – 0.4 MPa (43–57 psi) |
Brush / Roller
| Parameter | Value |
|---|---|
| Recommended Thinner | T-284 |
| Volume of Thinner | 0 – 5% |
Important Note
- Product is not recommended for continuous immersion in water or continuous splash of water
SAFETY INFORMATION
- Avoid inhalation of solvent vapours or paint mist
- Avoid contact of liquid paint with skin & eyes
- Ensure forced ventilation when applying in confined or stagnant areas
- Even with ventilation, always use respiratory, skin and eye protection when spraying
- Refer to the Material Safety Data Sheet (MSDS) before use
STORAGE & PACKING
Storage
- Store in a cool, dry place
- Store as per local regulations
Packing
- 20 litres pack
REFERENCES
Product Information Sheet – APCOMIN Industrial Synthetic Enamel
Issued by Asian Paints Ltd. – June 2010
Document Version: PC 2111
Source: https://www.asianpaints.com
Technical Guidelines & Explanatory Notes
Last accessed: 28 May 2025
Reference link:
https://www.asianpaints.com/service-support/technical-guidelines
Note: Always refer to the latest version of the Product Data Sheet on the manufacturer’s website for the most updated and accurate information.
Delivering Trusted Paint Solutions Since 1978. Authorized Distributor of 13+ Leading Paint Brands Across India.
OPENING HOURS
-
Monday - Sunday
08:00AM - 08:00PM