PRODUCT DATASHEET

TECHNICAL DATA

DIRECTIONS FOR USE

Surface Preparation & Substrate Condition

• For steel, non-ferrous metals and galvanised surfaces:
  Remove oil, grease, or other contaminants from the surface.
• Alloys that oxidise must be lightly sanded to remove all loose material.
• Substrate temperature must be at least 3°C above the dew point, and below 50°C.

MIXING

• Stir base and hardener separately.
• If settling is observed, loosen material with hand stirrer followed by power-driven stirrer for homogeneous mixing.
• Combine components and mix as follows:

Note: Mixed paint not used after 8 hours must be discarded.

APPLICATION

Brush (Only for touch-up areas)

• Recommended thinner: T-180 (also for cleaning)

Air Spray

Special Instructions

• Spray application is the preferred method.
• This wash primer is not intended for use as a shop primer for steel and must be recoated with a primer coat before exposure — preferably within 24 hours.
• Product does not hide the base metal; gives a yellowish tinge.
• Do not build thickness over 10 microns — excess deposition can lead to loss of adhesion to metal.

STORAGE & PACKING

Storage

• Store in a cool, dry place
• Store as per local regulations

Packing

• 20 litres
• 4 litres

SAFETY INFORMATION

• Avoid inhalation of solvent vapours or paint mist
• Avoid contact with skin & eyes
• Provide forced ventilation in confined spaces
• Even with ventilation, always use respiratory, skin, and eye protection when spraying
• Refer to Material Safety Data Sheet (MSDS) before use

REFERENCES

Product Information Sheet – APCONYL WP 636
Issued by Asian Paints (India) Ltd. – November 2003
Document Version: PC 335
Source: https://www.asianpaints.com

Technical Guidelines & Explanatory Notes
Last accessed: 28 May 2025
Reference link:
https://www.asianpaints.com/service-support/technical-guidelines

Note: Always refer to the latest version of the Product Data Sheet for precise and updated information.